105
Configuring Motion and
Proximity
Introduction
This chapter describes the auto-triggering feature of triggerless RS6000 models and provides programming bar
codes for configuring this feature.
Motion and proximity detection can be enabled or disabled by the EMDK application, 123Scan
2
or by scanning
configuration bar codes (see Configuring Motion and Proximity on page 107).
Operation Modes
The RS6000 can be configured to a single or continuous scan operation. In most use cases, a single scan mode is
the preferred operation. However, when scanning packages off a moving conveyor belt, it is sometimes
recommended to use the continuous scan mode (also referred to as 'Proximity Continuous' mode). Continuous
operation automatically results from the combined settings of motion and proximity (enabling or disabling motion
and/or proximity. See Table 8). The RS6000 is provided with motion and proximity enabled by default.
To set new values to the motion and/or proximity attributes, refer to Configuring Motion and Proximity on page 107.
NOTE: Once configured, the motion and/or proximity settings are retained in the RS6000 memory following
warm or cold boot.
Table 8 RS6000 Operation Modes
Mode
Number
Parameter States
(Motion / Proximity / Continuous
Scan)
Description
1 Motion: enabled
Proximity: enabled
Continuous scan: disabled
The RS6000 performs a single scan when moved and
positioned in proximity to an object.
Scanning resumes when the RS6000 is moved and
re-positioned in proximity to an object.
This mode is the default mode.
2 Motion: disabled
Proximity: enabled
Continuous scan: disabled
The RS6000 performs a single scan when positioned in
proximity to an object. The RS6000 stops scanning when the
object is out of proximity range.
To Next Page
Loading...
Need help?
General
