Bluetooth Communications
61
Wi-Fi Friendly Mode
Scanners configured for Wi-Fi friendly mode behave as follows:
• The RS6000 remains in sniff mode, and exits sniff mode only during firmware update.
• If any Wi-Fi channel is excluded from the hopping sequence, AFH turns off.
• RS6000 avoid the selected Wi-Fi channels after establishing connection.
Notes
• If using this feature, configure all RS6000 in the area for Wi-Fi friendly mode.
• By default, no Wi-Fi channels are excluded.
• Since Bluetooth requires a minimum of 20 channels when Wi-Fi channels 1, 6, and 11 are excluded,
a smaller number of channels are cut from the hopping sequence.
• Updating Wi-Fi friendly settings before Bluetooth connection is recommended.
Scan a bar code below to enable or disable Wi-Fi Friendly Mode, then see Wi-Fi Friendly Channel Exclusion to
select any channels to exclude.
*Disable Wi-Fi Friendly Mode
Enable Wi-Fi Friendly Mode
To Next Page
Loading...