Bluetooth Communications
50
7. Open the incoming COM port assigned (for example, COM7) in the application. After the COM port is opened
the computer connects to the RS6000 and a beep will sound. For demonstration, refer to General Bluetooth
Options on page 57.
How to Demonstrate SPP Connection with a Computer
Once SPP connection is established, an application is required to demonstrate the RS6000.
To scan a bar code:
1. If the RS6000 is still connected to the PC Tool application, close the COM port on the PC Tool application.
2. Run a hyper terminal application such as the Tera Term application. (ayera.com/teraterm/download.cfm).
Figure 26 Tera Term Application Screen
3. Select the virtual COM port set for the RS6000 connection.
4. Scan bar codes. Successful decoding of a bar code is indicated by one green flash of the Scan LEDs and a
high beep sound. In case of Bluetooth disconnection, the RS6000 emits one high beep followed by four low
beeps.
NOTE: Make sure the same COM port is closed in other applications.
To Next Page
Loading...
Need help?
General
