Zebra RS6000 - Page 380

To Next Page

To Previous Page

Country Codes

380

Country keyboard type: Romanian (Standard)

Default code page: CP1250

Missing characters:

Country keyboard type: Portuguese-Brazilian (ABNT), Portuguese-Brazilian (ABNT2)

Default code page: CP1252

Missing character:

₢

Country keyboard type: Azeri-Latin

Default code page: CP1254

Missing characters: ə , Ə

ҹҸ

ҝҜ

Table 34

șȘ

țȚ

Table 33

Main Page

Copyright2
Terms of Use2
Revision History2
About This Guide13
- Introduction13
- Documentation Set13
- Model Configurations14
- Chapter Descriptions14
- Notational Conventions15
- Related Documents15
- Service Information15
- Provide Documentation Feedback16
Getting Started17
- Introduction17
- Unpacking17
- Configuration Features18
- Status Indications19
- RS6000 Activity Modes20
- Configuration21
- Bluetooth Connection23
- Scanning23
  - Scan Triggering Modes23
    - Manual Triggering (Triggered models only)23
    - Auto-triggering (Triggerless models only)23
  - Aiming the RS600024
- Resetting the RS600025
Bluetooth Communications27
- Introduction27
  - Scanning Sequence Examples27
  - Errors While Scanning27
- Bluetooth Communications Parameter Defaults28
- Bluetooth Status Indications29
- Bluetooth Connection Modes29
- Keyboard Emulation29
- HID Options34
- Simple Serial Interface41
  - SSI Setup41
- Serial Port Profile44
  - SPP Setup44
- General Bluetooth Options57
Accessories81
- Accessories81
- 1-Slot RS6000 USB Charging Cradle83
- 2-Slot WT6000/RS6000 USB Charging Cradle86
- 5-Slot RS6000 Charge Only Cradle89
- 10-Slot WT6000/RS6000 Charge Only Cradle92
- 10-Slot RS6000 Charge Only Cradle95
  - Charging the RS600096
  - Battery Charging96
- 4-Slot Battery Charger97
- 20-Slot Battery Charger99
RS6000 Configuration and Update101
- Introduction101
- Configuring the RS6000101
- Real Time Logger102
  - Retrieving the RS6000 Log File102
- RS6000 Firmware Update103
  - Direct USB using 123Scan2104
  - Bluetooth connected WT6000104
Configuring Motion and Proximity105
- Introduction105
- Operation Modes105
- Configuring Motion and Proximity107
- Proximity Distance109
- Good Scan Indication Delay Control110
Miscellaneous Imager Options112
- Introduction112
- Scanning Sequence Examples113
- Errors While Scanning113
- User Preferences/Miscellaneous Options Parameter Defaults113
- User Preferences115
  - Default Parameters115
- Parameter Bar Code Scanning116
- Beep After Good Decode117
  - Beep on Insertion117
- Beeper Volume118
- Beeper Tone119
- Beeper Duration120
  - Suppress Power Up Beeps120
- Low Battery Indication121
- Hand-Held Trigger Mode122
- Hand-Held Decode Aiming Pattern123
- Picklist Mode124
- FIPS Mode125
- Continuous Bar Code Read126
  - Unique Bar Code Reporting126
- Decode Session Timeout127
- Timeout Between Decodes, Same Symbol128
- Timeout Between Decodes, Different Symbol129
  - Fuzzy 1D Processing129
- Decode Mirror Images (Data Matrix Only)130
- Mobile Phone/Display Mode131
- PDF Prioritization132
- PDF Prioritization Timeout133
  - Decoding Illumination133
- Motion Tolerance134
- Miscellaneous Scanner Parameters134
  - Add an Enter Key134
  - Transmit Code ID Character134
  - Prefix/Suffix Values135
  - Scan Data Transmission Format136
  - FN1 Substitution Values138
  - Transmit “No Read” Message139
Symbologies140
- Introduction140
- Scanning Sequence Examples140
- Errors While Scanning140
- Symbology Parameter Defaults141
- Enable/Disable All Code Types147
- UPC/EAN148
  - Enable/Disable UPC-A148
  - Enable/Disable UPC-E148
  - Enable/Disable UPC-E1149
  - Enable/Disable EAN-8/JAN-8149
  - Enable/Disable EAN-13/JAN-13150
  - Enable/Disable Bookland EAN150
  - Decode UPC/EAN/JAN Supplementals151
- User-Programmable Supplementals154
  - UPC/EAN/JAN Supplemental Redundancy154
- UPC/EAN/JAN Supplemental AIM ID Format155
- UPC Reduced Quiet Zone156
  - Transmit UPC-A Check Digit156
  - Transmit UPC-E Check Digit157
  - Transmit UPC-E1 Check Digit157
  - UPC-A Preamble158
- UPC-E Preamble159
- UPC-E1 Preamble160
- Convert UPC-E to UPC-A161
  - Convert UPC-E1 to UPC-A161
- EAN-8/JAN-8 Extend162
- Bookland ISBN Format163
- UCC Coupon Extended Code164
- Coupon Report165
- ISSN EAN166
- Code 128167
  - Enable/Disable Code 128167
- Set Lengths for Code 128168
- Enable/Disable GS1-128 (formerly UCC/EAN-128)170
  - Enable/Disable ISBT 128170
- ISBT Concatenation171
- Check ISBT Table172
  - ISBT Concatenation Redundancy172
- Code 128 Security Level173
- Code 128 Reduced Quiet Zone174
  - Ignore Code 128 <FNC4>174
- Code 128 Exclusive175
- Code 39176
  - Enable/Disable Code 39176
  - Enable/Disable Trioptic Code 39176
  - Convert Code 39 to Code 32177
- Code 32 Prefix178
- Set Lengths for Code 39179
  - Code 39 Check Digit Verification180
  - Transmit Code 39 Check Digit180
  - Code 39 Full ASCII Conversion181
- Code 39 Security Level182
- Code 39 Reduced Quiet Zone183
  - Code 39 Buffering - Scan & Store183
- Code 93186
  - Enable/Disable Code 93186
  - Set Lengths for Code 93186
- Code 11188
  - Code 11188
  - Set Lengths for Code 11188
- Code 11 Check Digit Verification190
- Transmit Code 11 Check Digits191
- Interleaved 2 of 5 (ITF)192
  - Enable/Disable Interleaved 2 of 5192
- Set Lengths for Interleaved 2 of 5193
- I 2 of 5 Check Digit Verification195
- Transmit I 2 of 5 Check Digit196
  - Convert I 2 of 5 to EAN-13196
- I 2 of 5 Security Level197
- I 2 of 5 Reduced Quiet Zone198
- Discrete 2 of 5 (DTF)199
  - Enable/Disable Discrete 2 of 5199
- Set Lengths for Discrete 2 of 5200
- Codabar (NW - 7)202
  - Enable/Disable Codabar202
  - Set Lengths for Codabar202
- CLSI Editing204
  - NOTIS Editing204
- Codabar Upper or Lower Case Start/Stop Characters Detection205
- MSI206
  - Enable/Disable MSI206
  - Set Lengths for MSI206
- MSI Check Digits208
  - Transmit MSI Check Digit(s)208
- MSI Check Digit Algorithm209
- Chinese 2 of 5210
  - Enable/Disable Chinese 2 of 5210
- Matrix 2 of 5211
  - Enable/Disable Matrix 2 of 5211
  - Set Lengths for Matrix 2 of 5211
- Matrix 2 of 5 Check Digit213
  - Transmit Matrix 2 of 5 Check Digit213
- Korean 3 of 5214
  - Enable/Disable Korean 3 of 5214
- Inverse 1D215
- GS1 DataBar216
  - GS1 DataBar-14216
  - GS1 DataBar Limited216
  - GS1 DataBar Expanded217
  - Convert GS1 DataBar to UPC/EAN217
  - GS1 DataBar Limited Security Level218
- Composite219
  - Composite CC-C219
  - Composite CC-A/B219
- Composite TLC-39220
- UPC Composite Mode221
- Composite Beep Mode222
  - GS1-128 Emulation Mode for UCC/EAN Composite Codes222
- 2D Symbologies223
  - Enable/Disable PDF417223
  - Enable/Disable MicroPDF417223
  - Code 128 Emulation224
- Data Matrix225
  - GS1 Data Matrix225
- Data Matrix Inverse226
  - Maxicode226
  - QR Code227
  - GS1 QR227
- MicroQR228
  - Inverse QR228
  - Aztec229
  - Aztec Inverse229
  - Han Xin230
  - Han Xin Inverse230
- Postal Codes231
  - US Postnet231
  - US Planet231
  - Transmit US Postal Check Digit232
  - UK Postal232
- Transmit UK Postal Check Digit233
  - Japan Postal233
- Australia Post234
- Australia Post Format235
- Netherlands KIX Code236
  - USPS 4CB/One Code/Intelligent Mail236
- UPU FICS Postal237
  - Mailmark237
- Canada Post238
- Symbology-Specific Security Levels239
  - Redundancy Level239
- Security Level241
  - 1D Quiet Zone Level242
- Intercharacter Gap Size243
- Report Version243
- Macro PDF Features244
  - Flush Macro Buffer244
  - Abort Macro PDF Entry244
OCR Programming245
- Introduction245
- OCR Programming Parameters247
  - Enable/Disable OCR-A247
  - OCR-A Variant247
- Enable/Disable OCR-B249
- OCR-B Variant250
- Enable/Disable MICR E13B253
- Enable/Disable US Currency Serial Number254
  - OCR Orientation254
- OCR Lines256
- OCR Quiet Zone258
- OCR Template259
- OCR Check Digit Validation270
- Inverse OCR275
123Scan and Software Tools276
- Introduction276
- 123Scan276
- Scanner Control App (SCA)278
- Advanced Data Formatting (ADF)278
- Multicode Data Formatting (MDF)279
- Preferred Symbol279
Maintenance and Troubleshooting280
- Introduction280
- Maintenance280
- Battery Safety Guidelines280
- Long Term Storage281
- Cleaning Instructions281
- Comfort Pad Replacement284
  - Large Comfort Pad Removal284
- Small Comfort Pad Removal285
  - Small Comfort Pad Installation285
- Large Comfort Pad Installation286
- Trigger Assembly Replacement287
  - Trigger Assembly Removal287
  - Trigger Assembly Installation287
- Converting Between Trigger and Triggerless Configuration289
  - Convert to Trigger Assembly289
  - Convert to Triggerless Assembly290
- Finger Strap Replacement (Trigger Swivel Assembly)291
  - Finger Strap Removal (Trigger Swivel Assembly)291
- Finger Strap Installation (Trigger Swivel Assembly)292
- Finger Strap Replacement (Triggerless Strap Holder)293
  - Finger Strap Removal (Triggerless Strap Holder)293
  - Finger Strap Installation (Triggerless Strap Holder)293
- Strap Buckle Replacement294
  - Strap Buckle Removal294
  - Strap Buckle Installation294
- Troubleshooting295
  - RS6000295
  - Cradles296
Specifications297
- RS6000 Technical Specifications297
- Cradle Technical Specifications301
- Decode Distances305
- Decode Range Information306
  - Standard Range Decode Zone306
- Medium Range Decode Zone307
Standard Default Parameters308
- Standard Default Parameters Table308
Programming Reference317
- Symbol Code Identifiers317
- AIM Code Identifiers318
Alphanumeric and Numeric Bar Codes323
- Numeric Bar Codes323
- Cancel324
Sample Bar Codes342
- Code 39342
- UPC/EAN342
  - UPC-A, 100%342
  - EAN-13, 100%343
- Code 128343
- Interleaved 2 of 5343
- GS1 DataBar-14343
- PDF417344
- Data Matrix344
- Maxicode344
- QR Code345
- US Postnet345
- UK Postal345
Country Codes346
- Introduction346
- Country Keyboard Types (Country Codes)347
Country Code Pages362
- Introduction362
- Country Code Page Defaults362
- Country Code Page Bar Codes366
CKJ Decode Control375
- Introduction375
- CJK Control Parameters376
  - Unicode Output Control376
- CJK Output Method to Windows Host377
- Non-CJK UTF Bar Code Output379
  - Country Keyboard Type Missing Characters379
- Unicode/CJK Decode Setup with Windows Host381
  - Setting Up the Windows Registry Table for Unicode Universal Output381
  - Adding CJK IME on Windows381
- Selecting the Simplified Chinese Input Method on the Host382
- Selecting the Traditional Chinese Input Method on the Host383
ASCII Character Sets384
INDEX394

Zebra RS6000 - Page 380

Table of Contents

Other manuals for Zebra RS6000

Related product manuals