Ascotel IntelliGate 2025/2045/2065
336 Call Routing Part 2
Tab. 2.65: Routing parameter settings
Routing without direct dialling
An incoming call from the public network is routed on to the private leased-line
network in accordance with the information relating to the PISN subscriber allo-
cated via the call distribution element.
This is useful in only a few instances since all the calls are routed via the same call
distribution element.
Parameter Parameter value
Trunk group 1:
• Network interfaces Network interfaces in this trunk group
• Incoming connection Number of connections allowed simultaneously
• Network type Public
• Protocol DSS1
• Direct dialling plan 1 (number of a direct dialling plan)
• Call Distribution Element 1 (relevant only if no suitable DD number is found)
Direct dialling plan 1:
• DD number 30 2 (reference number of a call distribution element)
Call distribution element 2:
• Destinations Switching position 1: 330 (PISN Subscriber)
• Incoming connections Number of connections allowed simultaneously
Subscriber configuration PISN SC 330:
• Route 2 (route reference number)
• Number Not relevant in this case
Route 2:
• Trunk groups 2 (reference number of one or more trunk group(s))
• Digit barring Use or do not use digit barring
• Outgoing connections Number of connections allowed simultaneously
• Numbering plan identifier NPI PNP
• Type of number TON Unknown
Trunk group 2:
• Network interfaces Network interfaces of this trunk group
• Network type Private
• Protocol QSIG or QSIG / PSS1 ISO
To Next Page
Loading...
