Ascotel IntelliGate 2025/2045/2065
652 Planning DECT systems Part 3
Note:
The simultaneous measurement of radio units is not recommended for
measurement-related reasons.
Measuring the coverage ranges of the test radio units
This method is used for planning a new system with the aid of the equipment in
the test kit, i.e. there is no PBX already in operation.
The "Look Around" menu is used for listing, selecting and measuring radio units
"detected" by the handset:
Tab. 3.23: Indications in the "Look Around" menu
The "Tick State" menu defines the composition of the group of radio units
selected:
Tab. 3.24: Indications in the "Tick" menu
Tab. 3.25: Indications in the "Group" menu
Display Function
"Look" Access from the "Test" menu
"go"/"stop" Starts, stops the continuous measurement
"
¥" Presents one radio unit in each case from the list of all radio units received
"M" Access the selection menu
"C" Goes back to normal menu
Display Function
"tick" Includes the radio unit shown in the measurement
"
¥" Presents one radio unit in each case from the list of all radio units received
"M" Display of single or multiple radio units
"C" Goes back to "Look Around"
Display Function
"go" "stop" Starts / stops the continuous measurement
"clr" Deletes single or multiple radio units
"M" Selects a specific radio unit / go to "Idle Lock" menu
"C" Goes back to "Tick"
To Next Page
Loading...
