Aastra Ascotel IntelliGate 2025 - Page 878

Ascotel IntelliGate 2025/2045/2065
878 Function check Part 6
Test the overflow routing from PINX 1 to PINX 2 via PINX 3 and PINX 4
1. In PINX 1, assign to the route pointing to PINX 2 (route 5 in the example here)
only the trunk group with the lines to be tested (trunk group 6 in the example
here).
2. Call a subscriber on PINX 2.
3. Allocate all the trunk groups back to the route.
4. Repeat steps 1 to 3 with all the PINXs.
Testing outgoing traffic to the public network
1. Set up an external connection from a PINX using an exchange access prefix
(0 in this example).
2. Check the display on the terminal.
3. Test the overflow routing to the public network, proceed as described above.
Testing incoming traffic from the public network
1. Set up a connection from the public network to subscribers in the PISN.
2. Check the display on the terminal of the PISN subscribers.
3. Repeat the test with numbers which are meant to ring with a delay on the
Operator Console OC.