Gen II User Manual
12-7 – Honeywell Performance Chapter 12 Revision 2.20, 20
12.1.2.6. The Aircraft Select screen will be displayed. If conducting the run on EEC, N2
DEEC or -60/-62 N1 DEEC computers, use the [] key to scroll through the list of
available aircraft. When the name of the aircraft on which you are conducting the
calibration run appears, press [OK] to accept and continue. If connected to the N1
DEEC, the aircraft will be detected automatically.
12.1.2.7. The Engine Select screen will be displayed. If conducting the run on EEC, N2 DEEC
or -60/-62 N1 DEEC computers, use the [] key to scroll through the list of available
engine models. The list is restricted to those engine models that may be installed on
the aircraft model selected in the Aircraft Selection screen above. Double check the
engine model as an error in this selection can make significant differences in the
reduced data. If the engine model installed on the selected aircraft is NOT
AVAILABLE from the list, confirm that the cables are connected correctly and are
the correct ones for your airframe, and recycle power to the DEEC computer. If you
continue to be unable to find the correct engine model, contact ACES Systems by
To Next Page
Loading...
Need help?
General
