Gen II User Manual
3-5 – Using the Gen II Analyzer Chapter 3 Revision 2.10, April 20
3.1.3.2. – Exporting setups from the analyzer
Setups can be exported from the analyzer, see paragraph 3.4.4.5 below. After exporting
the setup, it will be saved in the “aces_export” folder. Remove the USB flash drive from
the analyzer and insert it into a USB port on the computer. When the device opens, select
the “aces_export” folder from the memory stick and open it. Copy the necessary setup
and paste a copy into the “aces_setups” folder. Eject and remove the USB flash drive
from the computer.
3.1.3.3. Import Setups from USB drive.
Carry the USB flash drive to the Gen II Analyzer and plug into an open USB port on the
front of the analyzer.
Turn the analyzer on by pressing the [ON/OFF] key.
From the Main Menu, select “Analyzer Management.”
To Next Page
Loading...
