Gen II User Manual
3-12 – Using the Gen II Analyzer Chapter 3 Revision 2.10, April 20
Once you select a job and press [OK], a progress indicator will be displayed. During this process,
the analyzer will display the “Creating Report” banner screen. As progress is made in completing
the report, the page number and status bar will update.
After the report is created, the screen will change to indicate that the process is complete. Also,
the left-hand side of the screen “Pending Reports” value will increase with the addition of the
new report which is now ready to transfer. Press [F5] “Continue” to complete the process and
return to the “Create Job Report” to create your next report. Continue with the steps below to
transfer the reports to the USB flash drive.
To Next Page
Loading...
Need help?
General
