Chapter 2. Outdoor Installations
Vol. III-2-34 Alcatel-Lucent
8. Complete with a double-wrap overlay of vinyl tape.
9. Lightly coat the base of the suppressor support bracket, the ground lug, and
all three nuts with copper based grease.
10. Fit the support bracket to the suppressor studs and ODU ground stud. Hold in
place using the ground stud nut (loosely hand tighten only).
11. Attach the lugged end of the ground wire and secure with the star washers and
nuts supplied in the suppressor kit.
To Next Page
Loading...
