92 Rockwell Automation Publication 5069-UM002A-EN-P - January 2019
Chapter 3 Start to Use the Controller
Use the Logix Designer to Change the Operating Mode
To change the operating mode with the Logix Designer application, the
controller is online and the mode switch is in the REM position. The following
modes are available:
• Remote Program
• Remote Run
• Remote Test
Use the Controller Status menu to specify the operation mode.
TIP For this example, the controller mode switch is set to Remote mode. If the
controller mode switch is set to Run or Program modes, the menu options
change.
To Next Page
Loading...
