46 Rockwell Automation Publication 5069-UM002A-EN-P - January 2019
Chapter 2 Connect to the Controller
The new driver is available on the Configure Drivers dialog box.
Configure the Ethernet Devices Drivers in RSLinx Classic Software
The following conditions must exist to configure an Ethernet devices driver:
• The workstation is connected to another Ethernet network than the
target controller.
• The IP address and other network parameters are correctly configured
on the workstation.
To configure the Ethernet devices driver, complete these steps.
1. From the Communications pull-down menu, choose Configure Drivers.
To Next Page
Loading...
