Rockwell Automation Publication 5069-UM002A-EN-P - January 2019 155
Connect to Different EtherNet/IP Network Levels Chapter 6
Software Display Differences
for EtherNet/IP Modes
Table 9 shows differences in the Logix Designer application when the
controller uses Dual-IP mode or Linear/DLR mode.
The Controller Properties dialog box also provides a Network tab in the Logix
Designer application when the controller uses Linear/DLR mode. The
Network tab is not available when the controller uses Dual-IP mode.
Table 9 - EtherNet/IP Mode Display Differences in the Logix Designer Application
EtherNet/IP Mode
Section in
Application
Dual-IP Mode Linear/DLR Mode
I/O Configuration
Tree in Controller
Organizer
General Tab on
Controller
Properties Dialog
Box
Internet Protocol on
Controller
Properties Dialog
Box
To Next Page
Loading...
