Rockwell Automation Publication 5069-UM002A-EN-P - January 2019 49
Connect to the Controller Chapter 2
Configure the USB Communication Driver
You must use RSLinx Classic software, version 4.10.00 or later, or FactoryTalk
Linx software, version 6.10.00, with the CompactLogix 5480 controller.
A USB driver automatically appears in the software when you connect the
USB cable from your workstation to the controller. Once the cable is
disconnected, the driver disappears from the software.
If a USB driver does not appear automatically, you can complete the
following steps.
1. Confirm that the USB cable is connected to the controller.
The Found New Hardware Wizard dialog box appears.
2. Click any of the Windows Update connection options and click Next.
TIP If the software for the USB driver is not found and the installation is
canceled, verify that you have installed correct software.
To Next Page
Loading...
