Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
♦
Only loosen and tighten 12-point nut if vehicle stands on
wheels (risk of accident!).
♦
Do not move vehicle when 12-point nut is loosened. Other‐
wise, wheel bearing may be damaged.
♦
If the vehicle must be moved with the drive axle removed, in‐
stall the outer joint and tighten it to 150 Nm.
– Disconnect drive axle from rear final drive. Use Bits for Bits for
VAG1331/13 - 12mm - T10099- or Bits for Bits for
VAG1331/13 - 14mm - T10099/1- to loosen bolts -3-.
– Remove the bolt -2-.
– Remove both brackets with ABS speed sensor and brake wear
indicator electrical wiring at wheel bearing housing.
– Remove brake caliper and secure to body so that the weight
of the brake caliper does not stress or damage brake hose or
brake line ⇒ Rep. Gr. 46 .
– Remove nut from tie rod end and press tie rod end off of wheel
bearing housing.
– Remove nut from upper control arm and press arm off.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
102 Rep. Gr.40 - Front Suspension
To Next Page
Loading...
