Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Avoid contaminating with dirt and damaging the seal when setting
down/storing.
♦ The wheel bearing -1- must always face up.
♦ Always set the wheel bearing unit down on the wheel hub
-2-.
6.2 Wheel Bearing Housing, Removing and
Installing
Special tools and workshop equipment required
♦ Torque Wrench 1332 40-200Nm - VAG1332-
♦ Torque Wrench 1410 - VAG1410-
♦ Wood block (hardwood) 30 x 50 x 1300 mm
Removing
Note
An axle alignment may be required. Refer to
⇒ “5 Wheel Alignment”, page 247 .
– With vehicles with air suspension, place vehicle on hoist, refer
to ⇒ “4 Positioning Vehicle on Hoist and Wheels”, page 10 .
– Remove the drive axle, refer to
⇒ “7.3 Drive Axle, Bolted Inner Joint, Removing and Installing”,
page 182 .
– Insert wood block between underbody -Arrow A- and upper
rear control arm -Arrow B-.
Wood block is needed to press wheel bearing housing down.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
170 Rep. Gr.42 - Rear Suspension
To Next Page
Loading...
