Audi Q7 2007 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Metal Valve Body
❑ Only install valve ac‐
cording to Parts Cata‐
log.
❑ Delivered complete.
❑ Replace valve insert
with every tire change.
❑ Removing and Instal‐
ling, refer to
⇒ “4.8 Metal Valve
Body, Removing and In‐
stalling”, page 245 .
2 - Valve Insert
3 - Seal
❑ Removing and Instal‐
ling, refer to
⇒ “4.8 Metal Valve
Body, Removing and In‐
stalling”, page 245 .
4 - Rim
❑ Tires, mounting and dis‐
mounting, refer to
⇒ Fig. ““Dismounting
Tire”“ , page 245 and
⇒ Fig. ““Mounting Tire”“ ,
page 245 .
5 - Tire Pressure Sensor
❑ Must be completely re‐
placed.
❑ Remaining battery life,
temperature and pres‐
sure can be read via di‐
agnosis with -Vehicle
Diagnostic Tester- .
6 - TORX - T20- Micro-Encap‐
sulated Bolt
❑ Tightening specification, 4 Nm
❑ Screws must be replaced.
❑ Is only available with metal valve as replacement part.
7 - Union Nut
❑ Tightening specification, 4 Nm
❑ Removing and Installing, refer to ⇒ “4.8 Metal Valve Body, Removing and Installing”, page 245 .
8 - Beveled Washer
4.7 Tires, Changing
Nickel-plated valve insert must be replaced with every tire
change.
The metal valve and the tire pressure sensor can be used again.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
244 Rep. Gr.44 - Wheels, Tires, Wheel Alignment

Audi Q7 2007 Specifications

General

Brand	Audi
Model	Q7 2007
Category	Automobile
Language	English