Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Lift the wheel bearing housing with the Engine/Gearbox Jack
- VAG1383A- until dimension -a- is reached.
WARNING
♦ Do not lift or lower vehicle when the Engine/Gearbox Jack
- VAG1383A- stands below the vehicle.
♦ Do not leave Engine/Gearbox Jack - VAG1383A- below
vehicle any longer than necessary.
– Tighten the bolts and nuts.
– Lower the wheel bearing housing.
– Remove Engine/Gearbox Jack - VAG1383A- from under the
vehicle.
– Remove Engine/Gearbox Jack Adapter - Wheel Hub Support
- T10149- .
1.5 Wheel Bearing in Control Position, Lift‐
ing Vehicles with Air Suspension
Special tools and workshop equipment required
♦ Engine/Gearbox Jack - VAG1383A-
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
♦ Engine/Gearbox Jack Adapter - Wheel Hub Support - T10149-
♦ Air Line Insert Tool - T10212-
Bonded rubber bushings can only be turned to a limited extent.
Before axle components with bonded rubber bushings are tight‐
ened, they have to be brought to a position which matches the
position when the vehicle is being operated (control position).
Otherwise the rubber mounting will be stressed, resulting in a re‐
duced service life.
This position can be simulated on the lifting platform by raising
the wheel bearing housing using Engine/Gearbox Jack -
VAG1383A- and Engine/Gearbox Jack Adapter - Wheel Hub
Support - T10149- .
Requirement:
• Engine must be installed.
– Place vehicle on hoist, refer to
⇒ “4 Positioning Vehicle on Hoist and Wheels”, page 10 .
– Perform system vent using -Vehicle Diagnostic Tester- , refer
to ⇒ “3.9 System, Venting or Filling”, page 221 .
– Clean area around wiring connection.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
120 Rep. Gr.42 - Rear Suspension
To Next Page
Loading...
