Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
31 - Self-Locking Nut
❑ With securing plate
❑ Always replace if removed.
32 - Bolt
❑ 150 Nm + 90°
❑ Always replace if removed.
33 - Bolt
❑ 150 Nm + 90°
❑ Always replace if removed.
34 - Self-Locking Nut
❑ Always replace if removed.
3.2 Lower Control Arm, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Torque Wrench 1332 40-200Nm - VAG1332-
Removing
Note
An axle alignment may be required. Refer to
⇒ “5 Wheel Alignment”, page 247 .
– With vehicles with air suspension, place vehicle on hoist, refer
to ⇒ “4 Positioning Vehicle on Hoist and Wheels”, page 10 .
– Remove wheel.
– If equipped, remove stone impact protection from lower control
arm.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
140 Rep. Gr.42 - Rear Suspension
To Next Page
Loading...
