Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Use the upper screw -1- and lower screw -2- for precision ad‐
justment in “Guided Fault Finding”.
WARNING
The ACC adjustment is only accepted if “actuator test ended”
is displayed in -Vehicle Diagnostic Tester- .
– Switch ignition off.
– Disconnect Diagnostic Cable - VAS 5051/5A- connector from
diagnostic connection.
– Disconnect battery charger ⇒ Rep. Gr. 27 .
– Install license plate holder ⇒ Rep. Gr. 63 .
6.6 Adaptive Cruise Control Sensor -
G550- , Removing and Installing
The Adaptive Cruise Control Sensor - G550- is located behind the
license plate holder in the front bumper.
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Removing
Note
Due to limited space, it is necessary to remove the screws from
the bumper cover and to pull bumper cover forward slightly when
Removing and Installing.
– Remove the lock carrier cover -1-, refer to ⇒ Rep. Gr. 63 .
– Remove screws -2-.
– Remove license plate holder -3-, refer to ⇒ Rep. Gr. 63 .
– First release connector -1- and then remove.
– Rotate fasteners -2- approximately 45° left and remove.
– Remove the Adaptive Cruise Control Sensor - G550- forward
through the bumper cover.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
268 Rep. Gr.44 - Wheels, Tires, Wheel Alignment
To Next Page
Loading...
Need help?
General
