Audi Q7 2007 - Wheel Bearing Housing, Wheel Hub and Wheel Bearing; Wheel Bearing Housing, Wheel Hub and Wheel Bearing Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6 Wheel Bearing Housing, Wheel Hub
and Wheel Bearing
⇒ “6.1 Wheel Bearing Housing, Wheel Hub and Wheel Bearing
Overview”, page 168
⇒ “6.2 Wheel Bearing Housing, Removing and Installing”,
page 170
⇒ “6.3 Wheel Hub and Wheel Bearing, Removing and Installing”,
page 172
⇒ “6.4 Bonded Rubber Bushing, Removing and Installing”,
page 177
6.1 Wheel Bearing Housing, Wheel Hub and Wheel Bearing Overview
-Arrow A- points in direction of travel.
1 - Bracket
2 - Bolt
❑ 8 Nm
3 - Nut
❑ Self-locking
❑ Always replace if re‐
moved.
4 - Upper Front Control Arm
❑ Removing and Instal‐
ling, refer to
⇒ “3.4 Upper Front Con‐
trol Arm, Removing and
Installing”, page 141 .
5 - Bolt
❑ 150 Nm + 90°
❑ Always replace if re‐
moved.
6 - Drive Axle
❑ Removing and Instal‐
ling, refer to
⇒ “7.3 Drive Axle, Bolted
Inner Joint, Removing
and Installing”,
page 182 .
❑ Before assembling, coat
splines with Assembly
Paste .
❑ On vehicles with bon‐
ded drive shaft, clean
the spline, remove
grease and apply Lock‐
ing Compound to the
spline.
7 - Bolt
❑ 90 Nm + 90°
❑ Always replace if removed.
8 - Suspension Strut
❑ Suspension strut (air suspension), Removing and Installing, refer to
⇒ “4.2 Air Suspension Strut, Removing and Installing”, page 146 .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
168 Rep. Gr.42 - Rear Suspension