Audi Q7 2007 - System, Venting or Filling; Control Position, Programming

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– “34 - Level control (Repair group 01: 43, 44)”.
– “01 - On Board Diagnostic (OBD) capable systems”
– “J197 - Level control system control module functions”.
– “G341 - Left Front Body Acceleration Sensor”.
or
– “G342 - Right Front Body Acceleration Sensor”.
or
– “G343 - Rear Body Acceleration Sensor”.
3.9 System, Venting or Filling
– Connect -Vehicle Diagnostic Tester- and then perform vehicle-
specific entry into Guided Fault Finding and select Go To
button “function/component selection”, refer to
⇒ “2.6 Vehicle Diagnostic Tester , Connecting and Selecting
Functions”, page 211 .
Then
– “Chassis (Repair group 01; 40 - 49)”
– “34 - Level control (Repair group 01: 43, 44)”.
– “01 - On Board Diagnostic (OBD) capable systems”
– “J197 - Level control system control module functions”.
– “J197 - System venting or filling”.
3.10 Control Position, Programming
– Connect -Vehicle Diagnostic Tester- and then perform vehicle-
specific entry into Guided Fault Finding and select Go To
button “function/component selection”, refer to
⇒ “2.6 Vehicle Diagnostic Tester , Connecting and Selecting
Functions”, page 211 .
Then
– “Chassis (Repair group 01; 40 - 49)”
– “34 - Level control (Repair group 01: 43, 44)”.
– “01 - On Board Diagnostic (OBD) capable systems”
– “J197 - Level control system control module functions”.
– “J197 - Adapting control position”.
Note
If the control position was programmed on vehicles with lane as‐
sist, the Directional Stabilization Assistance Control Module -
J759- with integrated Camera must be calibrated, refer to
⇒ page 271 .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
3. Self-Leveling Suspension, Servicing 221