Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Installing
Installation is the reverse of removal, with special attention to the
following:
– Tighten the connections -1- and -2- by hand.
– Set dimension -A-.
A = 155 mm
For illustrative purposes, control arm adjuster is shown removed.
– Tighten connections -1- and -2-.
Tightening specifications, refer to
⇒ “3.1 Coil Spring Suspension Strut, Upper Control Arm, Mount‐
ing Bracket, and Level Control System Sensor Overview”,
page 46 .
– Suspension strut (coil spring), installing, refer to
⇒ “3.2 Coil Spring Suspension Strut, Removing and Installing”,
page 48 .
3.5 Upper Control Arm, Repairing
Special tools and workshop equipment required
♦ Subframe Bushing Tool Kit - 3301-
♦ Press Plate - VW401-
♦ Press Piece - Multiple Use - VW412-
♦ Press Piece - Multiple Use - VW426-
♦ Wishbone Rubber Mount Assembly Tool - T10219-
• The upper control arm us removed, refer to
⇒ “3.4 Upper Control Arm, Removing and Installing”,
page 53 .
– Mark the position of the bonded rubber mount on the basis of
the slot -arrow- with respect to the upper control arm.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
54 Rep. Gr.40 - Front Suspension
To Next Page
Loading...
