Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
00 – General, Technical Data
1 Technical Data
(Edition 01.2014)
⇒ “1.1 Chassis”, page 1
⇒ “1.2 Steering”, page 2
1.1 Chassis
Front Axle Double wishbone axle with subframe, stabilizer bar and twin gas-filled struts. Steel sus‐
pension or option
air suspension with variable damping characteristics
Rear Axle Double wishbone axle with loose upper steering levels, subframe, stabilizer bar and twin
gas-filled struts. Steel suspension or option
air suspension with variable damping characteristics
All Wheel Drive
Standard Suspen‐
sion 1BA
Comfort Suspen‐
sion USA 1BW
Air Suspension
1BK
Sport Suspension
(quattro GmbH)
1BV
Wheelbase
mm approximately 3002 approximately 3002 approximately
3006
approximately 3002
Front track mm approximately 1651,
refer to
1)
approximately
1651, refer to
1)
approximately
1654, refer to
1)
3)
approximately
1651, refer to
2)
Rear track mm approximately 1681
1)
approximately 1681
1)
approximately
1686
1)
3)
approximately 1681
2)
Maximum
steering angle
at curved inner
wheel with long
steering arm,
refer to
⇒ “3.5 Steering
Arm, Measur‐
ing Mechani‐
cally”,
page 302 .
De‐
gree
41° 12′ 41° 12′ 41° 12′ 41° 12′
Maximum
steering angle
at curved inner
wheel with
short steering
arm, refer to
⇒ “3.5 Steering
Arm, Measur‐
ing Mechani‐
cally”,
page 302
De‐
gree
38° 38° 38° 38°
1) These specified values correspond to a wheel offset of ET 53 mm.
2) These specified values correspond to a wheel offset of ET 52 mm.
3) These specified values correspond to the standard level on an air spring sus‐
pension.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
1. Technical Data 1