Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press “SETUP” function button. “adaptive air suspension”
menu appears.
– Rotate control knob to “Trailer mode” and select “OFF” in order
to switch off trailer mode.
– Turn off the ignition.
More details about trailer mode, refer to the Owner's Manual.
2.5 Cargo Mode
Special tools and workshop equipment required
♦ -Vehicle Diagnostic Tester- with corresponding diagnostic ca‐
ble.
Cargo mode can only be activated and deactivated with -Vehicle
Diagnostic Tester- .
If cargo mode was activated, it is not possible to activate a differ‐
ent level using MMI.
Activating or deactivating
– Connect -Vehicle Diagnostic Tester- and select functions, re‐
fer to
⇒ “2.6 Vehicle Diagnostic Tester , Connecting and Selecting
Functions”, page 211 .
Then
– “Chassis (Repair group 01; 40 - 49)”.
– “34 - Level control (Repair group 01: 43, 44)”.
– “01- On Board Diagnostic (OBD) capable systems”.
– “34 - Level control system control module ”.
– “J197 - Activating or deactivating cargo mode”.
2.6 -Vehicle Diagnostic Tester- , Connect‐
ing and Selecting Functions
Special tools and workshop equipment required
♦ -Vehicle Diagnostic Tester- with corresponding diagnostic ca‐
ble.
WARNING
♦ During a test drive, the testing and measuring equipment
must always be secured on the back seat.
♦ These devices may be operated only by a passenger dur‐
ing a test drive.
– Connect -Vehicle Diagnostic Tester- with corresponding diag‐
nostic cable to vehicle.
– Switch -Vehicle Diagnostic Tester- on.
-Vehicle Diagnostic Tester- is ready to operate when it displays
operating modes in button fields.
– Turn on the ignition.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
2. Air Spring Suspension Settings Vehicle Diagnostic Tester , Connecting and Selecting Functions 211