Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4.5 Air Supply Unit without Solenoid Valve
Block, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
♦ Standard socket open end 12 mm
Removing
– Place vehicle on hoist, refer to
⇒ “4 Positioning Vehicle on Hoist and Wheels”, page 10 .
– Perform system vent at front axle with -Vehicle Diagnostic
Tester- ⇒ page 221 .
– Remove right underbody trim, refer to ⇒ Rep. Gr. 50 .
– Disconnect intake line -1- at clutch.
– Disconnect the electrical connections -1- and -2- between the
air supply unit and the body.
– Remove cable ties -arrows-.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
228 Rep. Gr.43 - Self-Leveling Suspension
To Next Page
Loading...
