Audi Q7 2007 - Page 147

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
10 - Self-Locking Nut
❑ 90 Nm + 90°
❑ Always replace if removed.
11 - Self-Locking Nut
❑ 180 Nm
❑ Always replace if removed.
12 - Eccentric Washer
13 - Tie Rod
❑ Removing and Installing, refer to ⇒ “3.6 Tie Rod, Removing and Installing”, page 143 .
14 - Eccentric Screw
15 - Eccentric Screw
16 - Eccentric Washer
17 - Self-Locking Nut
❑ 180 Nm
❑ Always replace if removed.
18 - Left Rear Level Control System Sensor - G76- and Right Rear Level Control System Sensor - G77-
❑ Removing and Installing, refer to ⇒ “3.3 Vehicle Level Sensor, Removing and Installing”, page 141 .
19 - Bolt
❑ 4 Nm
20 - Self-Locking Nut
❑ 8 Nm
❑ Always replace if removed.
21 - Self-Locking Nut
❑ 8 Nm
❑ Always replace if removed.
22 - Upper Front Control Arm
❑ Removing and Installing, refer to
⇒ “3.4 Upper Front Control Arm, Removing and Installing”, page 141 .
23 - Bracket
24 - Bolt
❑ 150 Nm + 90°
❑ Always replace if removed.
25 - Upper Rear Control Arm
❑ Removing and Installing, refer to ⇒ “3.5 Upper Rear Control Arm, Removing and Installing”, page 142 .
26 - Washer
27 - Self-Locking Nut
❑ Always replace if removed.
28 - Bolt
❑ 150 Nm + 90°
❑ Always replace if removed.
29 - Wheel Bearing Housing
❑ Removing and Installing, refer to ⇒ “6.2 Wheel Bearing Housing, Removing and Installing”, page 170 .
30 - Self-Locking Nut
❑ Always replace if removed.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
3. Lower Control Arm, Level Control System Sensor, Upper Front and Upper Rear Control Arms and Tie Rod 139