Audi Q7 2007 - Page 129

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove connector piece -1- at residual pressure retaining
valve -2- using Air Line Insert Tool - T10212- . Air escapes
then.
– Seal both connections. Make sure that no dust particles enter
connections.
– Turn the wheel hub until one of the holes for the wheel bolts
is on top.
– Install Engine/Gearbox Jack Adapter - Wheel Hub Support -
T10149- with wheel bolt.
– Insert Engine/Gearbox Jack Adapter - Wheel Hub Support -
T10149- into Engine/Gearbox Jack - VAG1383A- and press
wheel bearing housing far enough upward until control posi‐
tion, dimension -a-, is obtained.
Control position
♦ Dimension -a- for vehicles with air suspension 465 mm
WARNING
♦ Do not lift or lower vehicle when the Engine/Gearbox Jack
- VAG1383A- stands below the vehicle.
♦ Do not leave Engine/Gearbox Jack - VAG1383A- below
vehicle any longer than necessary.
Working After Adjusting Control Position
– Tighten the bolts and nuts.
– Lower the wheel bearing housing.
– Remove Engine/Gearbox Jack - VAG1383A- from under the
vehicle.
– Remove Engine/Gearbox Jack Adapter - Wheel Hub Support
- T10149- .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
1. General Information 121