Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Level the bubble level -B- using the adjusting screw -2-.
Perform Any Subsequent Work Using the Vehicle Diagnosis Test‐
er.
– Turn on the ignition.
– Touch Guided Fault Finding .
– Select in succession:
♦ Brand
♦ Type
♦ Model year
♦ Version
♦ Engine Code
– Confirm data entered.
Wait until the -Vehicle Diagnostic Tester- has checked all availa‐
ble control modules in vehicle.
– Press the go to button and select “function/component se‐
lection”.
Then
– “Body (Repair Group 01; 27; 50 - 97)”.
– “Electrical System (Repair group 01; 27; 50 - 97)”.
– “01- On Board Diagnostic (OBD) capable systems”.
– “5C - Lane assist”.
– “J759 - Directional stabilization assistance control module
functions”.
– “J759 - Calibration”.
Now follow the instructions on the screen to perform the calibra‐
tion.
Note
A step is performed in guided fault finding next to determine the
body height.
– Determine the body height -a- at all four wheels in the center
of the wheel between the wheel contact surface and the lower
edge of the fender.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
276 Rep. Gr.44 - Wheels, Tires, Wheel Alignment
To Next Page
Loading...
