Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Location of hoses on reservoir and reservoir bracket to body
– Position reservoir -4- on bracket -3- when installing.
– Tighten the bracket -2- with the bolts -1- to 8 Nm.
– Markings -7- on suction and return hose -8- must align with
webs -5-. Secure suction hose and return line -8- with hose
clamps -6-.
Return Line Clip to Refrigerant Line, Return Line to Refrigerant
Line Bracket
– Secure return line -1- with clip -2- two times on refrigerant line
-3-.
– Secure return line -1- with line bracket -4- to refrigerant line
bracket -5-.
Hoses to Hydraulic Oil Cooler
– Attach return line -4- to line -1- and return hose -6- to line -7-.
– Markings -5- on return line -4- and return hose -6- must align
with markings -2-. Secure return line -4- and return hose -6-
with hose clamps -3-.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
8. Power Steering Pump, Hydraulic Pipes and Reservoir 367
To Next Page
Loading...
