Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Secure Power Steering Test Unit - VAG1402- -3- with a cable
tie -2- to stabilizer bar -1-.
– Remove banjo bolt -6-.
– Attach adapter as shown in figure.
1 - Power Steering Test Unit - VAG1402-
2 - Power Steering Test Unit - Adapter Hose - VAG1402/6-
3 - Adapter - V.A.G 1402/4-
4 - Seal
5 - Power Steering Pump
6 - Banjo Bolt
7 - Pressure Line
8 - Adapter - V.A.G 1402/2-
– Remove the Hose Clamps - Up To 25mm - 3094- .
Make sure that lever on pressure gauge stands in position -2-.
– Start engine and fill hydraulic fluid in reservoir if necessary.
– Turn steering wheel from stop to stop approximately 10 times.
Note
♦
To avoid damage to pump, note the following:
♦
Pressure gauge shut-off valve must not remained closed lon‐
ger than 10 seconds during this test.
♦
Start engine without giving gas and run at idle.
♦
Read the pump pressure immediately after starting at idle
speed (have it read by second technician, if necessary).
♦
Because pressure falls over the course of the test, the highest
pressure shown is the decisive measurement.
– Now check delivery pressure.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
370 Rep. Gr.48 - Steering
To Next Page
Loading...
