Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Grasp air spring rolling pistons -1- with both hands and slide
them with light right/left rotation upward in
-direction of arrow- from shock absorber.
The entire air spring must rotate with it.
Note
Make sure that rolling piston -1- does not slip down out of outer
guide -2-.
Note
If air spring is reused and air spring has slipped out of outer guide,
it must be slid in again by forming even circumferential folds on
the rolling bellows -arrows-.
– When replacing air spring, slide stop buffer -1- down out of air
spring centering seat.
Stop buffer is reused.
– Remove boot from collar on shock absorber -arrow- and re‐
move it from shock absorber.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
4. Air Suspension Strut, Upper Control Arm and Level Control System Sensor 73
To Next Page
Loading...
