R5910032 /00 Freya110
3. Select a test Pattern (e.g. Focus green) and adjust lens settings (lens shift, focus and zoom) if needed. For
more detail concerning lens settings in lens control panel, please see “Light, dowser, lens”, page 63.
Note: Zoom and Focus are not available when the non-motorized lens file is selected.
4. Click Save (reference 3).
7.4.4 Activating a lens position file
What is possible
Usually a lens position file is activated via a macro but it is possible to directly activate it by clicking on
Activate in the contextual menu.
How to activate
1. While in Configuration > Projector > Lens position, find and click on the lens position file you want to
activate.
The lens position file is displayed in its expanded form with menu.
Image 7–67
2. Click Activate in the menu.
The new configuration is applied. Status of the lens position file turns to Active and its name is noticed on
top of the list.
7.4.5 Renaming a lens position file
How to rename
1. While in Configuration > Projector > 3D, find and click on the 3D file you want to rename.
The 3D file is displayed in its expanded form with menu.
Configuration - Projector
To Next Page
Loading...
