Barco Freya - Media Player for ICMP

R5910032 /00 Freya138
5. Use the plus button or minus button to adjust Gamma parametric value (reference 5) depending on the
source.
6. Select the desired color correction.
The following corrections are possible:
• Enable dual eye color correction (reference 6) must be not checked to chose “single eye” color
correction.
• Enable dual eye color correction (reference 6) must be checked to chose “dual eye” color correction
(separate eyes).
7. Depending on your selection, detailed settings can be set.
When Override settings (reference 7) are not overruled (not checked), Color Space and 3D are
automatically set with the info given in the Info Frames inside the HDMI signal.
When Override settings (reference 7) are checked,
• Color Space (reference 9) can be set between RGB or YCbCr.
• Force 3D can be enabled or disabled (reference 8).
7.6.3.3 Media player for ICMP
How to adjust media player parameters for ICMP
1. While in input file editor, click Media Player (reference 1).
1
2
3
4
5
Image 7–112
2. If not already done, click Select (reference 2) to specify that Media Player is right now the source format
select for this file.
3. Select the desired color correction.
The following corrections are possible:
• Enable dual eye color correction (reference 3) must be not checked to chose “single eye” color
correction.
• Enable dual eye color correction (reference 3) must be checked to chose “dual eye” color correction
(separate eyes).
4. Select EOTF (Electro-Optical Transfer Function) curve (reference 4).
The following choices are possible:
• HDR must be checked to chose “High Dynamic Range” content.
• Standard must be checked to chose standard content.
5. Use the plus button or minus button to adjust Gamma parametric value (reference 5) depending on the
source.
Configuration - Projector