Barco Freya - Network Configuration; About Network Configuration

R5910032 /00 Freya256
14.1 Network configuration
14.1.1 About network configuration
Location & access
Menu: Configuration > System access> Network configuration
Level: Administrator, Service technician
Overview
This panel is used to define the network configuration of the projector and, when present, the network
configuration of the mediablock. Click on the network interface you want to set in the list (reference 1).
When the projector network interface (reference 2) is displayed, modify the auditorium name (reference 3) and
configure the network.
A switch (reference 4) allows to choose the setting mode. Two configuration modes are available: Automatic
or Manual.
In manual mode, parameters (reference 5) are editable and must be adjusted manually.
In automatic mode, DHCP (Dynamic Host Configuration Protocol) server provides settings which will be
applied to the projector's network configuration. Network parameters (reference 5) are not editable (greyed
out).
Host name is editable in both cases.
1
3
4
5
8
7
2
6
Image 14–1
Allow legacy protocol check box (reference 6) must be activated when a third party equipment need to send
API over Ethernet commands to the Freya projector using the legacy protocol as used on Series 2 projectors.
Configuration - System access