Barco Freya - Linked CLO (Adding, Modifying, Verifying and Deleting a Slave Projector)

279R5910032 /00 Freya
2. Edit the desired values (reference 3 to 5),
Note: Please refer to section “Linked ICMP (Adding, modifying and deleting a slave projector)”,
page 277 to correctly modify slave projector parameters.
3. Confirm modifications with OK (reference 6).
Slave projector is displayed in the Slave Projectors list with its new settings.
How to delete slave projector
1. While in tab linked ICMP in Configuration > System access > Multi projectors, click on Delete icon
(reference 1) of the projector slave you want to remove.
1
Image 14–27
Projector is removed from the Slave Projectors list without confirmation.
14.5.3 Linked CLO (Adding, modifying, verifying and deleting a slave
projector)
Location & access
Menu: Configuration > System access > Multi projectors
Level: Administrator, Service technician
To obtain an efficient linked CLO behaviour, the CLO sensor of each units of the group
(master and slaves) need to be correctly calibrated. Please refer to Configuration > Light
output > Sensor section.
How to add slave
1. While in tab linked CLO in Configuration > System access > Multi projectors, click on Add (reference 1).
A window Add projector as slave is displayed.
Configuration - System access