251R5910032 /00 Freya
13.4 Immersive sound
Location & access
Menu: Configuration > Media server > Immersive sound
Level: Administrator, Service technician
About immersive sound
As there are different audio processors in the market, some typical configurations must be done.
The audio processor should be configured by adding its IP address and activating the function in Web
Communicator. The protocol for the audio processor should be selected. Once all these actions are done, the
audio processor can be used in Web Commander.
How to setup and activate
1. While in Configuration > Media sever > Scheduler, enter the IP address/hostname of the immersive sound
input of the audio processor (reference 1).
Image 13–13
2. To activate, check the check box in front of Active (reference 2).
Checked: activated.
Unchecked: deactivated.
3. Select the audio processor protocol (reference 3). Click on the desired radio button.
When an APX AuroMax® processor is used, select the AuroMax protocol.
When an Dolby Atmos processor is used, select the Dolby Atmos protocol.
4. Click the Save button to save the immersive sound settings (reference 4).
Configuration - Media server
To Next Page
Loading...
Need help?
General
