R5910032 /00 Freya272
Each trap receivers is designed by its IP address (reference 3) in the Trap Destinations list.
Clicking on a trap receiver (reference 5) allows to show it in its expanded form (reference 6) and displays a
contextual menu.
Following actions are available in this menu:
• Edit (reference 7) allows to modify the IP address of the receiver.
• Delete (reference 8) allows to remove the receiver from the list.
Add (reference 4) allows to add a new receiver.
Image 14–17
14.4.2 Modifying the trap resend interval
Location & access
Menu: Configuration > System access > SNMP
Level: Administrator, Service technician
How to modify the trap resend interval
1. While in Configuration > System access > SNMP, click in Non critical traps field (reference 1), then enter
the time that the projector needs wait between two sends of non critical traps to the management server.
2. Click in Critical traps field (reference 2), then enter the time that the projector needs wait between two
sends of critical traps to the management server.
Image 14–18
3. Click Save (reference 3) to apply changes.
Configuration - System access
To Next Page
Loading...
Need help?
General
