R5910032 /00 Freya78
2. While in Configuration > Projector > Macros, click on the menu icon located on the top right of the list to
select New macro from active state.
The macro editor opens with a pre-filled macro (commands already present correspond to the current
state of the projector).
3. Finish the macro creation and save it as described in procedure “Creating a new macro”, page 77.
7.1.4 Macro editor
About this chapter
This chapter contains all the necessary information to use macro editor, the Web Communicator page used to
create or modify macros.
7.1.4.1 General
About Macro editor
Use the Macro editor to create or modify macros. This page is not directly accessible via a general menu.
Click Edit to modify a macro in a contextual menu (reference 1) or click New in the macro general menu to
create a new macro (reference 2). For more information, please consult the sections dedicated to these
operations in chapter “Macros configuration”, page 76.
The Macro editor consists of a commands set distributed in several tabs (reference 3) and an ordered list of
commands (reference 4). List of commands is empty when it’s a creation of a new macro.
The following actions are available:
• add commands from the command set to the list.
• delete some commands out of the list.
• change the order of the commands in the list.
• edit commands attributes.
Image 7–4
About Macros
A macro is a saved sequence of commands that can be stored and then easily recalled.
A macro can contain at least:
• an input file
• a screen file
• a PCF file
Configuration - Projector
To Next Page
Loading...
