107
of 328
Instruction handbook b maXX 5000
Document No.: 5.09021.16
6MOUNTING
The device is intended for mounting in a control cabinet.
Mounting comprises the following steps:
1 Mo
unting preparation
(for drilling holes/cutting out sections,
see ZDrilling pattern– as from page 111)
only with active mains rectifier to op
erate within C2 surrounding,
for drilling holes of toroidal cores,
see ZDrilling pattern toroidal cores– on page 119
2 Mo
unting
the device (for fixing, see ZMo
unting instructions– on page 113)
possibly mounting toroidal cores
(see ZMounting the toroidal
cores– as from page 120)
6.1 Safety notes
NOTE!
Mounting shall only be performed by employees of the manufacturer or by other qual-
ified personnel.
Qualified personnel are persons who – on acco
unt of their occupational training, ex-
perience, instruction and knowledge of releva
nt standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons re-
sponsible for the safety of the facilities
to perform the respective activities that are
necessary, while at the same time recognizing and preventing any potential risks.
The qualifications necessary for working with the device are, for example:
m Occupa
tional training or instruction in accordance with the standards of safety en-
gineering for the care and use of appropriate safety equipment.
To Next Page
Loading...
Need help?
General
