Baumuller b maXX 5000 - Page 122

Mounting instructions
Instruction handbook bmaXX 5000
Document No.: 5.09021.19 Baumüller Nürnberg GmbH
122
of 346
6.3
6.3.3 Mounting of the DC link bar
Observe the following items when mounting the DC link bar:
m Position of the chamber-bevel (detail Y)on bottom
Position of the screw thread (detail Z) on top.
The correctly mounting of the distance bushings makes it easier to disassemble the
unit in case of service and ensures the captivity of the distance bushings.
Neck collar screw (1)
DC link bar (2)
Distance bushing (3)
BM5XXX DC link terminal (4)
Figure 52: Correctly mounted DC link bar
m Distance bushing and neck collar screw
It is recommended to assemble the neck collar screw and the distance bushing to the
DC link bar before mounting the DC link bar. The correctly mounting of the distance
bushings makes it easier to disassemble the unit in case of service and ensures the
captivity of the distance bushings.
Figure 53: Mounting of the neck collar screw
WRONG CORRECT