Baumuller b maXX 5000 User Manual

Monitoring functions
Instruction handbook b maXX 5000
Document No.: 5.09021.16 Baumüller Nürnberg GmbH
236
of 328
10.2
Signal bus - Brake resistor on
This signal activates the brake resistors of several supplying devices simultaneously.
Both mains rectifier unit and mono units provide a brake resistor connection and an own
monitoring of the DC link voltage. If the DC link voltage exceeds a fixed threshold, the
brake resistor is switched on.
The axis units measure the DC link voltage also and can be configured to generate the
„Brake resistor on“ signal. If this signal is set, the brake resistor is switched on at the
mains rectifier unit and/or at the mono units.
This signal is not evaluated at the active mains rectifier unit.
Signal bus - Error
The axis units and the mono units can be configured to set the „Error“ signal on the signal
bus as soon as the device is no longer in state ready-to-operate.
Furthermore each axis unit or each mono unit can be configured to generate an error
message when detecting an „Error“ signal. A simple error reaction for all axis units/mono
units is possible, using this function.
This signal is neither evaluated nor set at the active mains rectifier unit and at the mains
rectifier unit.
Signal bus - Signal bus warning
Connected devices can exchange warning states among each other with this signal. The
signal is evaluated or set only by axis units and mono units. It is neither evaluated nor set
by the active mains rectifier unit and by the mains rectifier unit.

Baumuller b maXX 5000 Specifications

General

Brand	Baumuller
Model	b maXX 5000
Category	Servo Drives
Language	English