Belarus 82.3 - Page 231

82.3-0000010 OM
231
Table 6.10.1 continued
Failure,
external manifestation, cause
Troubleshooting
Draft control unit handle fails to return on its own from
the “raising” position to the “transport neutral” position
Jamming in the connections of the
control handle to the draft control
unit
Eliminate jamming, clean surfaces of articulations from
traces of corrosion, apply a layer of lubricant if necessary
Detent spring bolt on the control
handle overtightened
Adjust the tension of the detent spring on the control han-
dle
Draft control unit rod adjusted in-
correctly
Adjust the length
1, 3 – bolts of lever hubs; 2- RLL shaft.
Figure 6.10.1 - Tightening of bolts of the lever hubs on the intermediate shaft
Note - The hydraulic circuit diagram for the HLL with draft control unit is presented
in Annex B in Figure B1.