BERTHOLD TECHNOLOGIES Uni-Probe LB 490 - Page 10

38477BA2B
10 25.5.09
Contents Volume 1-7
2.35 DIG. OUTPUT TEST ............................................. 3 – 330
2.36 C
URRENT OUTPUT ............................................... 3 – 331
2.37 P
ROBE SETTINGS................................................. 3 – 332
2.38 HV S
ETTINGS ...................................................... 3 – 334
2.39 P
LATEAU ............................................................... 3 – 335
2.40 HART I
NTERFACE ............................................... 3 – 336
3 Getting Started via the HART
®
Communicator................ 3 – 337
3.1 Steps for Getting Started ........................................ 3 – 337
3.2 Setup Protocol........................................................ 3 – 338
4 Calibration...................................................................... 3 – 341
4.1 Preparing Calibration.............................................. 3 – 341
4.2 Operation Modes for Calibration ............................ 3 – 348
4.3 Two-Point Calibration ............................................. 3 – 350
4.4 One-Point Calibration ............................................. 3 – 357
4.5 Multi-Point Calibration ........................................... 3 – 360
5 Functional Processes ....................................................... 3 – 367
5.1 Plateau Measurement............................................. 3 – 367
5.2 Changing the Uni-Probe Password.......................... 3 – 369
5.3 Set Multi-Detector Mode ........................................ 3 – 371
6 Explanations ................................................................... 3 – 373
6.1 Background............................................................ 3 – 373
6.2 Conditions for Empty Calibration............................ 3 – 375
6.3 Linear and Exponential ........................................... 3 – 377
6.4 Multi-Point Calibration ........................................... 3 – 380
6.5 Radiation Interference Detection............................. 3 – 383
6.6 Reading-in Pulse Rates............................................ 3 – 386
6.7 Software Versions................................................... 3 – 388
7 Error Handling ................................................................ 3 – 393
7.1 Device Response to Errors....................................... 3 – 393
7.2 Error Handling Modes............................................. 3 – 394
7.3 Corrective Action.................................................... 3 – 395
7.4 Reset ...................................................................... 3 – 397
7.5 Operation Modes during Measurement .................. 3 – 397
7.6 Error Reset.............................................................. 3 – 398
7.7 Fault Current .......................................................... 3 – 399
8 Setup Protocol ................................................................ 3 – 401
8.1 Parameter List......................................................... 3 – 401
8.2 Calibration Values................................................... 3 – 402