BERTHOLD TECHNOLOGIES Uni-Probe LB 490 - Setup Protocol

38477BA2B
3 – 338 25.5.09
3 Getting Started via the HART
®
Communicator Volume 3
3.2 Setup Protocol
3.2.1 Parameter list
 After commissioning, enter the parameters in the following
parameter list in order to document the start-up.
TAG No. Date
Isotope Activity
Source no. Detector
Conveyor belt HV
Product
Function Range SETUP
Password Configuration
0 - 999999
Password Config. & Calibrate
0 - 999999
Password Full Access
0 - 999999
Date
YY.MM.DD Current date
Time
HH.MM Current time
Descriptor
e.g. LB490 Vers
Message
Tag
Distributor
Isotope
Co, Cs
No. of Probes
Level Unit
Temp. Unit
Error Handling
Time Constant
s
Damping Mode
Interference Mode
Sigma
Pulse rate Upper Limit
Pulse rate Lower Limit