Uni-Probe LB 490
BERTHOLD TECHNOLOGIES GmbH & Co. KG
1 – 27
Volume 1 4 Transport and Assembly
1
4 Transport and Assembly
The weight of the source shielding may be up to several 100kg,
depending on the version. Please keep in mind:
• The bearing capacity of the container walls or the brackets
must be suitable for installation of the source with the shielding
and of the detector. Otherwise, system parts may fall off and
cause severe injuries or bodily harm with fatal consequences.
• Make sure that the mechanical stability of the fixing devices
matches the weight of the shielding.
Please keep in mind:
– Never step under hovering loads while unloading heavy system
parts!
– Only use tested lifting equipment matching the transport
weights.
– Maintain adequate safety margins.
– Wear hard hat and safety shoes.
Explosion hazard!
If the screw thread on the cover or on one of the four screwed
cable glands is damaged, the Uni-Probe cannot be used any more
in ex-protected areas. If the Uni-Probe housing receives a mechan-
ical blow, e.g. because it is dropped, then you have to return the
Uni-Probe to BERTHOLD TECHNOLOGIES GmbH & Co. KG for
inspection.
To Next Page
Loading...
