38477BA2B
3 – 398 25.5.09
7 Error Handling Volume 3
7.6 Error Reset
If an error or a warning is identified, an error message is displayed.
This error message must be reset. If the error still occurs after
resetting, it will be indicated again on the display.
In our example “Message 21” is displayed which is triggered when
the max. count rate is exceeded.
Push
NEXT to reset the message.
Push
NEXT to reset the message.
Select …
– NO to reset this error message, or
–
YES if you also want to ignore the next 50 error messages.
Only error messages on the HART
®
will be ignored. The error
relay of the Uni-Probe responds immediately, as soon as the
error occurs again.
The next window is the one that has been displayed prior to the
error message.
To Next Page
