Uni-Probe LB 490
BERTHOLD TECHNOLOGIES GmbH & Co. KG
3 – 369
Volume 3 5 Functional Processes
3
5.2 Changing the Uni-Probe Password
Passwords rule out that parameters can be changed by unauthor-
ized persons. To allow you to check the Uni-Probe even in the
locked status, the levels LIVE DISPLAY and VIEW PARAMETER are
not password-protected and are therefore always accessible. On
these levels, parameters can be read, but not edited.
In the Uni-Probe you can clear parameter levels specifically. Up to
3 different passwords can be used. Passwords may even be identi-
cal; in this case, they open several levels at the same time.
On the
CHANGE PASSWORD level you can rename the passwords.
Clear access If the password has not already been changed by the user, you can
grant access to all levels with the standard password
UNIPROBE.
Block access By entering 00000000, all levels containing parameters that can be
changed, are locked.
The table shows that a higher level also unlocks the levels below it.
For example, if password 3 has been cleared, access to all levels
below it is also granted.
Prerequisite for changing the password is that you have access to
the level CHANGE PASSWORD.
live display
view parameter
Configuration
CONFIGURATION &
CALIBRATION
Service
Change Password
Password 3 Full Access XXXXX
Password 2 Configuration &
Calibration
XXX X
Password 1 Configuration XX X
00000000 Read only X
Access to level
Password Description
To Next Page
