Uni-Probe LB 490
BERTHOLD TECHNOLOGIES GmbH & Co. KG
7 – 665
Volume 7 3 Parameter Overview
7
3 Parameter Overview
The following tables include all parameters that are needed for con-
figuration and operation with FOUNDATION
™
Fieldbus. The tables
are sorted in alphabetical order, so that you can quickly find the
parameter you are looking for. Behind the parameter description
you find cross-references to the chapters describing the setting or
use of this particular parameter.
3.1 Parameters for the Function Block
Resource
Parameter name Description
DD_REV Revision number of the device description for Uni-Probe LB 490
DEV_REV Revision number of LB 490
DEV_Type Device type number
ERROR_LOG_DATA
DEVICE_ID
ERROR_CODE
ERROR_TIME
Error information. See also chapter 7.1 on page 7–715.
ID of the device in which the error has occurred. The ID is attached on the
outside of each Uni-Probe.
Error code number. See section 5.10 on page 7–699.
Date and time the error has occurred.
ERROR_LOG_ENTRY Number of the error displayed in ERROR_LOG_DATA. Enter a value
smaller or equal to the number of errors that have occurred
(ERROR_LOG_NUMBER) to view the error information in
ERROR_LOG_DATA.
ERROR_LOG_NUMBER Total number of errors in the log
FBK_VERSION
FBK_SERIAL_NUMBER
FBK_HARDWARE_VERSION
FBK_HARDWARE_TYPE
FBK module version. The FBK module is the fieldbus module installed in
the Uni-Probe.
Serial number of the fieldbus module
Version number of the fieldbus module
Hardware type of the fieldbus module.
HARDWARE_REVISION Hardware version number of the Uni-Probe LB 490
ITK_VER Version number of the interoperability test kit which was used to test the
Uni-Probe LB 490.
RS_STATE Status of the function block
SOFTWARE_REVISION Version number of the embedded software of the Uni-Probe LB 490
ST_REV Version number of the static data of the function block. Incremented by
one whenever the static data change.
WRITE_LOCK Prevents modification of parameters in the Uni-Probe. See section 5.9 on
page 7–699.
To Next Page
Loading...
